WIN 10 not seeing FC v1.03 after successful FW update

User helping User!

WIN 10 not seeing FC v1.03 after successful FW update

Postby STUCARIUS » 20 May 2016 01:27

I successfully did a complete FW update to my new v1.03 FC, installed updated drivers first but now when I connect the FC I get a device malfunctioned and failed to install.

What's up? I can go back into the Demo and still update but the device will not load afterward or allow me to see it in the GUI and set the com port.

Is there a way to completly reset the FC to it factory default at all levels and start again? Or better yet how do I just get it to work?

Thanks.
STUCARIUS
 
Posts: 2
Joined: 20 May 2016 01:22

Re: WIN 10 not seeing FC v1.03 after successful FW update

Postby STUCARIUS » 20 May 2016 01:50

OK here is what I had to do. I had to strip everything out and reinstall all to the most current stable FW. The beta FW will install but it is breaking the device's ability to load its drivers in Win 10 at least. I really wanted to try out the new sbus features but I guess it is better to have a working FC than a brick :D

I hope this helps you guys at Flyduino...
STUCARIUS
 
Posts: 2
Joined: 20 May 2016 01:22


Return to Problems

Who is online

Users browsing this forum: No registered users and 1 guest

cron