flashing esc32 firmware

User helping User!

flashing esc32 firmware

Postby avlmche » 19 Sep 2014 16:46

Hi evrybody!

I'm trying to flash esc firmware.

The esc guide says to connect FTDI/USB adapter to esc, then select power of logic side (me 5V, done) and then to shortened boot jumper and power on.

In Qgroundcontrol software, I connect the appropriate COM port and the I press the button: flash firmware that is the following: "ESC32v20r49",

but after few seconds appear the following message:

"ESC32 not in bootloader mode already...

Connecting to ESC32...".
Probly I've not understood what is the meaning of bootloader mode.

So at the end of the day I'm not able to flash the esc firmware.

Somebody can help me?

Thanks a lot.
avlmche
 
Posts: 4
Joined: 21 Jul 2014 10:10

Return to Problems

Who is online

Users browsing this forum: No registered users and 1 guest

cron